Atlas Copco PowerMACS 4000

Appendix
9836 3521 01 635
Code
Comp
Code
Type
Severity
Event string
2207
902
Hardware
Error
IO: Node %d, Sig %d, referring address %d on fieldbus
2400
260
System
Error
Zip expand failed. Error %d, size in %d, size out: %d
2401
261
System
Error
Zip compress failed. Error %d, size in %d, size out: %d
2701
681
Hardware
Error
No angle channel found
2702
682
Hardware
Error
No torque channel found
2802
345
System
Error
Invalid communication port %d for device
2900
347
System
Error
Unexpected signal
3100
348
System
Error
Hunt for station failed
3101
349
System
Error
TestBolt: DB read error, code %d
3102
350
Setup
Error
TestBolt: No station defined in the setup
3103
351
General
Error
TestBolt: Disabled by PLC for station %d
3201
352
System
Error
PLC: Run time system error (code 0x%x, info 0x%x)
3202
353
System
Error
PLC: Bootfile access error (error %d)
3203
354
System
Error
PLC: Only one input and one output 'EXTCOM' driver allowed
(now %d and %d)
3204
355
System
Error
PLC: 'EXTCOM' area (input %d + output %d) is too big (max %d
bytes)
3205
356
Setup
Error
PLC: 'ANYBUS' variables defined but no Fieldbus device exists
3206
357
Setup
Error
PLC: Only one 'ANYBUS' input/output driver is allowed (now %d
and %d)
3207
358
Setup
Error
PLC: 'ANYBUS' input area (%d) is too big. Fieldbus declares
only %d bytes
3208
359
General
Error
PLC: User event %d generated
3209
360
Setup
Error
PLC: 'ANYBUS' output area (%d) is too big. Fieldbus declares
only %d bytes
3210
567
General
Error
PLC: The target device for DEVCMD does not exist
3211
568
General
Error
PLC: Device %d on TC %d is not allowed as target for DEVCMD
(wrong type %d)
3212
569
General
Error
PLC: Failed to send DEVCMD %d to device %d on TC %d
3215
896
Setup
Error
PLC: LIO driver will not be used. Use I/O device instead.
3216
958
System
Error
PLC: Illegal channel no %d.
3303
364
Setup
Error
Fieldbus on TC %d: Config. error. Max output size=%d, max
input size=%d
3305
366
Setup
Error
Fieldbus on TC %d: Board type mismatch, type connected=%d,
type configured=%d
3307
368
Setup
Error
Fieldbus on TC %d: Configured Node addr.(%d) is out of range