Atlas Copco PowerMACS 4000

Appendix
9836 3521 01 641
Code
Comp
Code
Type
Severity
Event string
3901
416
Setup
Error
GM DeviceNet: Input area (%d) is wrong size. Fieldbus declares
only (%d) bytes
3902
417
Setup
Error
GM DeviceNet: Output area (%d) is wrong size. Fieldbus
declares only (%d) bytes
3903
418
System
Error
Hunt for station failed
4013
685
Check
Error
Step %d, Check: Yield Point check failed, no yield point found
4015
686
Check
Error
Step %d, Check: Yield Point check failed, not possible to
measure angle
4016
687
Check
Error
Step %d, Check: Yield Point Angle high, %f > %f
4017
688
Setup
Error
Step %d, Check: Yield Point Angle low, %f < %f
4018
689
Check
Error
Step %d, Check: Stick-Slip has bad configuration
4101
476
Ext. com.
Info
ACTA: Batch result received. (torque flags=%d, angle flags=%d,
pulses flags=%d)
4103
595
Ext. com.
Warning
ACTA: Set Torq SF failed for sp %d, too high diff (old = %f, new
= %f)
4104
596
Ext. com.
Error
ACTA: Set Torq Scale Factor failed for sp %d
4105
597
Ext. com.
Info
ACTA: Torq SF changed for T1 on spindle %d, old = %f, new =
%f
4106
598
Ext. com.
Info
ACTA: DATAHOLD or DATADROP used, no cycle data will be
avaliable for ACTA
4107
599
Ext. com.
Warning
ACTA: Set Torq SF failed for spindle %d, it is used more than
once in the cycle
4108
600
Ext. com.
Info
ACTA: Not possible to start tightening, spindle %d is not used in
mode %d
4201
650
Ext. com.
Error
DASP: TC %d: Message receiving error (0x%x)
4203
651
Ext. com.
Error
DASP: TC %d: Received wrong DLP task (task=%d), (key=%d)
4206
654
Ext. com.
Error
DASP: Servo on TC:%d has wrong LLP version (0x%x)
4207
655
Ext. com.
Error
DASP: Spindle on TC:%d has wrong LLP version (0x%x)
4208
656
Ext. com.
Error
DASP: TC %d: No servo connected
4209
657
Ext. com.
Error
DASP: TC %d: No spindle connected
4210
658
Ext. com.
Error
DASP: TC %d: Stream %d resend max time
4211
659
Ext. com.
Info
DASP: TC %d: New software has been downloaded to the servo
4212
660
Ext. com.
Info
DASP: TC %d: New software has been downloaded to the
spindle
4213
661
System
Error
DASP: TC %d: Update EEPROM in servo, command has
already been sent
4214
662
System
Error
DASP: TC %d: Bank select failed