Atlas Copco PowerMACS 4000

Appendix
642 9836 3521 01
Code
Comp
Code
Type
Severity
Event string
4215
663
System
Error
DASP: TC %d: Failed to read from device boot
4216
664
System
Error
DASP: TC %d: Application do not match this device (Model %d,
App %d)
4217
665
System
Error
DASP: TC %d: Device HW version too low (Variant %d, LowLim
%d)
4218
666
System
Error
DASP: TC %d: Device HW version too high (Variant %d,
HighLim %d)
4219
667
Ext. com.
Error
DASP: TC %d: Servo ALP version too high (Servo %d,
Supported up to %d)
4220
668
Ext. com.
Error
DASP: TC %d: Spindle ALP version too high (Spindle %d,
Supported up to %d)
4223
671
Ext. com.
Error
DASP: TC %d: Update EEPROM in spindle, command has
already been sent
4224
648
Ext. com.
Info
DASP: TC %d: Restarting servo and TC.
4225
649
Ext. com.
Info
DASP: TC %d: Restarting spindle.
4227
677
General
Error
TC %d: Incorrect spindle article number
4228
678
General
Warning
TC %d: Any Spindle article number in use
4229
679
General
Error
TC %d: Simulated Spindle and Servo in use
4230
680
System
Info
TC %d, Replaced ramp down with i. brake (too short time
between start/stop)
4231
903
General
Info
Conv. Box: TC %d, New box detected
4232
904
General
Error
Conv. Box: TC %d, Failed to program box with reference values
from setup
4233
905
General
Error
Conv. Box: TC %d, Motortune is required and calibration is
recommended
4234
906
General
Info
Conv. Box: TC %d, Box programmed successfully
4235
907
General
Warning
Conv. Box: TC %d, Checksum faults detected. Verify spindle
calibration values
4401
554
General
Warning
Multiple ID: Bypassed Work Order position %d, which uses
Identifier Type %d
4501
703
Ext. com.
Error
ANYBUS: TC %d: Unable to initialize the serial channel
4502
704
Ext. com.
Error
ANYBUS: TC %d: Unable to configure the serial channel
4503
705
Ext. com.
Error
ANYBUS: TC %d: Driver Error! Severity (%d) Code (%d)
4504
706
Ext. com.
Warning
ANYBUS: TC %d: Connection to ABCC Recovered.
4505
707
Ext. com.
Info
ANYBUS: TC %d: Connection to ABCC lost!
4507
708
Ext. com.
Error
ANYBUS: TC %d: Error! No module connected!
4508
709
Ext. com.
Error
ANYBUS: TC %d: Error! Module not supported!