Atlas Copco PowerMACS 4000

Appendix
9836 3521 01 643
Code
Comp
Code
Type
Severity
Event string
4509
710
Ext. com.
Error
ANYBUS: TC %d: Error! Wrong anybus network module
mounted!
4510
711
Ext. com.
Error
ANYBUS: TC %d: Error! Attached module is not an AnyBusCC
module!
4511
712
Ext. com.
Error
ANYBUS: TC %d: Error! Exception (%d) in AnyBus module!
4512
713
Ext. com.
Error
ANYBUS: TC %d: Error! Read request offset (%d) is out of
range!
4513
714
Ext. com.
Error
ANYBUS: TC %d: Error! Write request offset (%d) is out of
range!
4514
715
Ext. com.
Error
ANYBUS: TC %d: Error! Failed to set up read map!
4515
716
Ext. com.
Error
ANYBUS: TC %d: Error! Failed to set up write map!
4516
717
Ext. com.
Error
ANYBUS: TC %d: Setup done!
4517
718
Ext. com.
Error
ANYBUS: TC %d: Error! Module version (%x) does not support
Extended Mode!
5001
751
Hardware
Error
TC %d, Servo Overtemp: Power Stage %f deg
5002
752
Hardware
Error
TC %d, Servo EEPROM Version Error
5003
753
Hardware
Error
TC %d, Servo Motor parameters invalid
5004
754
Hardware
Error
TC %d, Servo Motortune parameters invalid
5005
755
Hardware
Error
TC %d, Servo software error Id %d Code %d
5006
756
Hardware
Error
TC %d, Servo software warning Id %d Code %d
5007
757
Hardware
Error
TC %d, Servo Ref21 Error 0x%x
5020
758
Hardware
Error
TC %d, Spindle Overtemp: Motor %f deg, Chip %f deg
5021
759
Hardware
Error
TC %d, Spindle 5V Digital Torque Off
5022
760
Hardware
Error
TC %d, T1 Voltage Off
5023
761
Hardware
Error
TC %d, Spindle EEPROM Error. New spindle parameters
needed.
5024
762
Hardware
Error
TC %d, Torque 1 Low
5025
763
Hardware
Error
TC %d, Torque 1 High
5026
764
Hardware
Error
TC %d, Torque 2 Low
5027
765
Hardware
Error
TC %d, Torque 2 High
5028
766
Hardware
Error
TC %d, Torque 2 Voltage Off
5029
767
Hardware
Error
TC %d, Spindle Chassis ground error
5030
768
Hardware
Error
TC %d, Spindle Ref21 Error 0x%x
5040
769
System
Error
TC %d, Could not read ref %d from spindle
5041
770
System
Error
TC %d, Could not read ref %d from servo
5042
771
Hardware
Error
Step %d, Diagnostic: Shunt values T1 Offset %d, Gain %d