AudioCodes Mediant 3000 User Manual

User's Manual 1022 Document #: LTRT-89730
Mediant 3000
Parameter Description
Redirect Number SIP to
TEL
[SetIp2TelRedirectScreenin
gInd]
Defines the value of the Redirect Number screening indicator in ISDN
Setup messages.
 [-1] Not Configured (default)
 [0] User Provided
 [1] User Passed
 [2] User Failed
 [3] Network Provided
Set IP-to-TEL Redirect
Reason
[SetIp2TelRedirectReason]
Defines the redirect reason for IP-to-Tel calls. If redirect (diversion)
information is received from the IP, the redirect reason is set to the
value of the parameter before the device sends it on to the Tel.
 [-1] Not Configured (default)
 [0] Unkown
 [1] Busy
 [2] No Reply
 [3] Network Busy
 [4] Deflection
 [9] DTE out of Order
 [10] Forwarding DTE
 [13] Transfer
 [14] PickUp
 [15] Systematic/Unconditional
Set TEL-to-IP Redirect
Reason
[SetTel2IpRedirectReason]
Defines the redirect reason for Tel-to-IP calls. If redirect (diversion)
information is received from the Tel, the redirect reason is set to the
value of the parameter before the device sends it on to the IP.
 [-1] Not Configured (default)
 [0] Unkown
 [1] Busy
 [2] No Reply
 [3] Network Busy
 [4] Deflection
 [9] DTE out of Order
 [10] Forwarding DTE
 [13] Transfer
 [14] PickUp
 [15] Systematic/Unconditional
Send Screening Indicator to
IP
[ScreeningInd2IP]
Overrides the calling party's number (CPN) screening indication in the
received ISDN SETUP message for Tel-to-IP calls.
 [-1] Not Configured = (Default) Not configured (interworking from
ISDN to IP) or set to 0 for CAS.
 [0] User Provided = CPN set by user, but not screened (verified).
 [1] User Passed = CPN set by user, verified and passed.
 [2] User Failed = CPN set by user, and verification failed.
 [3] Network Provided = CPN set by network.
Note: The parameter is applicable only if the Remote Party ID (RPID)

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English