AudioCodes Mediant 3000 User Manual

User's Manual 1024 Document #: LTRT-89730
Mediant 3000
Parameter Description
 If there is a calling “display” name, it remains unchanged.

The redirect number remains unchanged and is included in the
SIP Diversion header.
Add Trunk Group ID as
Prefix
[AddTrunkGroupAsPrefix]
Determines whether the Trunk Group ID is added as a prefix to the
destination phone number (i.e., called number) for Tel-to-IP calls.
 [0] No = (Default) Don't add Trunk Group ID as prefix.
 [1] Yes = Add Trunk Group ID as prefix to called number.
Notes:
 This option can be used to define various routing rules.
 To use this feature, you must configure the Trunk Group IDs (see
Configuring Trunk Groups on page 461).
Add Trunk ID as Prefix
[AddPortAsPrefix]
Determines whether or not the port numberTrunk ID is added as a
prefix to the called (destination) number for Tel-to-IP calls.
 [0] No (Default)
 [1] Yes
If enabled, the device adds the following prefix to the called phone
number: port numberTrunk ID (single digit in the range 1 to 83).
This option can be used to define various routing rules.
Add Trunk Group ID as
Prefix to Source
[AddTrunkGroupAsPrefixTo
Source]
Determines whether the device adds the Trunk Group ID (from where
the call originated) as the prefix to the calling number (i.e. source
number).
 [0] No (default)
 [1] Yes
Replace Empty Destination
with B-channel Phone
Number
[ReplaceEmptyDstWithPort
Number]
Determines whether the internal channel number is used as the
destination number if the called number is missing.
 [0] No (default)
 [1] Yes
Note: The parameter is applicable only to Tel-to-IP calls and if the
called number is missing.
[CopyDestOnEmptySource] Determines whether the destination number is copied to the source
number if no source number is present, for Tel-to-IP calls.
 [0] = (Default) Source Number is left empty.
 [1] = If the Source Number of a Tel-to-IP call is empty, the
Destination Number is copied to the Source Number.
Add NPI and TON to
Calling Number
[AddNPIandTON2CallingNu
mber]
Determines whether the Numbering Plan Indicator (NPI) and Type of
Numbering (TON) are added to the Calling Number for Tel-to-IP calls.
 [0] No = (Default) Do not change the Calling Number.
 [1] Yes = Add NPI and TON to the Calling Number ISDN Tel-to-IP
call.
For example: After receiving a Calling Number of 555, NPI of 1, and
TON of 3, the modified number becomes 13555. This number can later
be used for manipulation and routing.
Add NPI and TON to Called
Number
[AddNPIandTON2CalledNu
mber]
Determines whether NPI and TON are added to the Called Number for
Tel-to-IP calls.
 [0] No = (Default) Do not change the Called Number.
 [1] Yes = Add NPI and TON to the Called Number of ISDN Tel-to-IP
call.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English