Version 7.0 55 Mediant 3000
User's Manual 5. Configuring an IP Address for Mediant 3000 HA
Note: If you want to change the global IP address at a later stage:
• If the current and new global IP addresses are in different subnets, then it’s
recommended to also define the private addresses of the blades in the same
subnet as the new global IP address. This allows the blades to send reports to a
Syslog server in case of major device failure.
• If the device is configured with VLAN interfaces, you must switch back to a single
interface configuration before changing the global IP address.
• Do not load a .cmp or an .ini file when using BootP/DHCP; otherwise, the current
configuration running on the device's flash memory will be erased.
To Next Page
Loading...
Need help?
General
