User's Manual 624 Document #: LTRT-89730
Mediant 3000
 To configure an IP-to-IP Inbound Manipulation rule:
1. Open the IP to IP Inbound Manipulation table (Configuration tab > VoIP menu > SBC
> Manipulations SBC > IP-to-IP Inbound).
2. Click Add; the following dialog box appears:
Figure 34-2: IP to IP Inbound Manipulation Table - Add Row Dialog Box
3. Configure the IP-to-IP inbound manipulation rule according to the parameters
described in the table below.
4. Click Add.
Table 34-1: IP to IP Inbound Manipulation Table Parameter Descriptions
Parameter Description
Index
[IPInboundManipulation_I
ndex]
Defines an index number for the new table record.
Note: Each table row must be configured with a unique index.
Routing Policy
[IPInboundManipulation_
RoutingPolicyName]
Assigns an SBC Routing Policy to the rule. The SBC Routing Policy
associates the rule with an SRD(s). The SBC Routing Policy also defines
default LCR settings as well as the LDAP servers if the routing rule is
based on LDAP routing (and Call Setup Rules).
If only one SBC Routing Policy is configured in the SBC Routing Policy
table, the SBC Routing Policy is automatically assigned. If multiple SBC
Routing Policies are configured, no value is assigned.
For configuring SBC Routing Policies, see ''Configuring SBC Routing
Policy Rules'' on page 616.
Note: The parameter is mandatory.
Manipulation Name
Defines an arbitrary name to easily identify the manipulation rule.
The valid value is a string of up to 20 characters. By default, no value is
defined.
To Next Page
Loading...
Need help?
General
