AudioCodes Mediant 3000 User Manual

Version 7.0 629 Mediant 3000
User's Manual 34. SBC Manipulations
Parameter Description
Additional Manipulation
[IPOutboundManipulation
_IsAdditionalManipulatio
n]
Determines whether additional manipulation is done for the table entry
rule listed directly above it.
 [0] No = (Default) Regular manipulation rule - not done in addition to
the rule above it.
 [1]
Yes = If the previous table row entry rule matched the call, consider
this row entry as a match as well and perform the manipulation
specified by this rule.
Note: Additional manipulation can only be done on a different item
(source URI, destination URI, or calling name) to the rule configured in
the row above (configured by the 'Manipulated URI' parameter).
Source IP Group
[IPOutboundManipulation
_SrcIPGroupName]
Defines the IP Group from where the INVITE is received.
The default value is Any (i.e., any IP Group).
Destination IP Group
[IPOutboundManipulation
_DestIPGroupName]
Defines the IP Group to where the INVITE is to be sent.
The default value is Any (i.e., any IP Group).
Source Username Prefix
[IPOutboundManipulation
_SrcUsernamePrefix]
Defines the prefix of the source SIP URI user name, typically used in the
SIP From header.
The default value is the asterisk (*) symbol (i.e., any source username
prefix). The prefix can be a single digit or a range of digits. For available
notations, see ''Dialing Plan Notation for Routing and Manipulation'' on
page 827.
Note: If you need to manipulate calls of many different source URI user
names, you can use tags (see 'Source Tags' parameter below) instead of
this parameter.
Source Host
[IPOutboundManipulation
_SrcHost]
Defines the source SIP URI host name - full name, typically in the From
header.
The default value is the asterisk (*) symbol (i.e., any source host name).
Source Tags
src-tags
[IPOutboundManipulation
_SrcTags]
Assigns a prefix tag to denote source URI user names corresponding to
the tag configured in the associated Dial Plan.
The valid value is a string of up to 20 characters. The tag is case
insensitive.
To configure prefix tags, see Configuring Dial Plans on page 633.
Note:
 Make sure that you assign the Dial Plan in which you have configured
the prefix tag, to the related IP Group or SRD.
 Instead of using tags and configuring the parameter, you can use the
'Source Username Prefix' parameter to specify a specific URI source
user or all source users.
Destination Username
Prefix
[IPOutboundManipulation
_DestUsernamePrefix]
Defines the prefix of the destination SIP URI user name, typically located
in the Request-URI and To headers.
The default value is the asterisk (*) symbol (i.e., any destination
username prefix). The prefix can be a single digit or a range of digits. For
available notations, see ''Dialing Plan Notation for Routing and

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English