User's Manual 692 Document #: LTRT-89730
Mediant 3000
2. Click Add; the following dialog box appears:
Figure 44-3: GW User Info Table - Add Row Dialog Box
3. Configure the GW User Info table parameters according to the table below.
4. Click Add.
5. To save the changes to flash memory, see ''Saving Configuration'' on page 672.
To register a user, select the user's table entry, and then from the Action button's drop-
down list , choose Register. To un-register a user, select the user, and then from the
Action button's drop-down list , choose Un-Register.
Table 44-2: GW User Info Table Parameter Descriptions
Parameter Description
Index
[GWUserInfoTable_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
PBX Extension
[GWUserInfoTable_PBXE
xtension]
Defines the PBX extension number.
The valid value is a string of up to 10 characters.
Note: The parameter is mandatory.
Global Phone Number
[GWUserInfoTable_Global
PhoneNumber]
Defines the "global" phone number for the IP side.
The valid value is a string of up to 20 characters.
Note: The parameter is mandatory.
Display Name
[GWUserInfoTable_Displa
yName]
Defines the Caller ID of the PBX extension.
The valid value is a string of up to 30 characters.
Username
[GWUserInfoTable_Usern
ame]
Defines the username for registering the user when authentication is
necessary.
The valid value is a string of up to 40 characters.
Password
[GWUserInfoTable_Passw
ord]
Defines the password for registering the user when authentication is
necessary.
The valid value is a string of up to 20 characters.
Status (Read-only field) Displays the status of the user - "Registered" or "Not
Registered".