AudioCodes Mediant 3000 User Manual

Version 7.0 815 Mediant 3000
User's Manual 56. Testing SIP Signaling Calls
Parameter Description
Test Mode
[Test_Call_TestMode
]
Defines the test session mode.
 [0] Once = (Default) The test runs until the lowest value between the
following is reached:

Maximum channels is reached for the test session, configured by
'Maximum Channels for Session'.

Call duration ('Call Duration') multiplied by calls per second ('Calls per
Second').

Test duration expires, configured by 'Test Duration'.
 [1] Continuous = The test runs until the configured test duration is
reached. If it reaches the maximum channels configured for the test
session (in the 'Maximum Channels for Session'), it waits until the
configured call duration of a currently established tested call expires
before making the next test call. In this way, the test session stays within
the configured maximum channels.
Note: The parameter is applicable only if 'Call Party' is set to Caller.
Test Duration
[Test_Call_TestDurati
on]
Defines the test duration (in minutes).
The valid value is 0 to 100000. The default is 0 (i.e., unlimited).
Note: The parameter is applicable only if 'Call Party' is set to Caller.
Play
[Test_Call_Play]
Enables and defines the playing of a tone to the answered side of the call.
 [0] Disable
 [1] DTMF = (Default) Plays a user-defined DTMF string, configured in
''Configuring DTMF Tones for Test Calls'' on page 818.
 [2] PRT = Plays a non-DTMF tone from the PRT file (Dial Tone 2). For this
option, a PRT file must be loaded to the device (see ''Prerecorded Tones
File'' on page 682).
Notes:
 To configure the DTMF signaling type (e.g., out-of-band or in-band) use
the 'DTMF Transport Type' parameter (see ''Configuring DTMF Transport
Types'' on page 213).
 The parameter is applicable only if 'Call Party' is set to Caller.
Schedule Interval
[Test_Call_ScheduleI
nterval]
Defines the interval (in minutes) between automatic outgoing test calls.
The valid value range is 0 to 100000. The default is 0 (i.e., scheduling is
disabled).
Note: The parameter is applicable only if 'Call Party' is set to Caller.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English