AudioCodes Mediant 3000 User Manual

User's Manual 814 Document #: LTRT-89730
Mediant 3000
Parameter Description
QoE Profile
[Test_Call_QOEProfil
e]
Assigns a QoE Profile to the test call.
By default, no value is defined (None).
To configure QoE Profiles, see ''Configuring Quality of Experience Profiles''
on page 309.
Bandwidth Profile
[Test_Call_BWProfile
]
Assigns a Bandwidth Profile to the test call.
By default, no value is defined (None).
To configure Bandwidth Profiles, see ''Configuring Bandwidth Profiles'' on
page 313.
Authentication Tab
Note: These parameters are applicable only if the Call Party parameter is set to Caller.
Auto Register
[Test_Call_AutoRegi
ster]
Enables automatic registration of the endpoint. The endpoint can register to
the device itself or to the 'Destination Address' or 'IP Group' parameter
settings (see above).
 [0] Disable (default)

[1]
Enable
Username
[Test_Call_UserNam
e]
Defines the authentication username.
By default, no username is defined.
Password
[Test_Call_Password
]
Defines the authentication password.
By default, no password is defined.
Test Setting Tab
Call Party
[Test_Call_CallParty]
Defines whether the test endpoint is the initiator or receiving side of the test
call.
 [0] Caller (default)

[1]
Called
Maximum Channels
for Session
[Test_Call_MaxChan
nels]
Defines the maximum number of concurrent channels for the
test session. For
example, if you have configured an endpoint "101" and you set the parameter
to "3", the device automatically creates three simulated endpoints - "101",
"102" and "103" (i.e., consecutive endpoint URIs are assigned).
The default is 1.
Call Duration
[Test_Call_CallDurati
on]
Defines the call duration (in seconds).
The valid value is -1 to 100000. The default is 20. A value of 0 means infinite.
A value of -1 means that the parameter value is automatically calculated
according to the values of the 'Calls per Second' and 'Maximum Channels for
Session' parameters.
Note: The parameter is applicable only if 'Call Party' is set to Caller.
Calls per Second
[Test_Call_CallsPerS
econd]
Defines the number of calls per second.
Note: The parameter is applicable only if 'Call Party' is set to Caller.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English