EasyManuals Logo

AudioCodes Mediant 3000 User Manual

AudioCodes Mediant 3000
1070 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #843 background imageLoading...
Page #843 background image
Version 7.0 843 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
[AUPDTftpBlockSize]
Defines the size of the TFTP data blocks (packets) when downloading a
file from a TFTP server for the Automatic Update mechanism. This is in
accordance to RFC 2348. TFTP block size is the physical packet size (in
bytes) that a network can transmit. When configured to a value higher
than the default (512 bytes), but lower than the client network’s Maximum
Transmission Unit (MTU), the file download speed can be significantly
increased.
The valid value is 512 to 8192. The default is 512.
Notes:
ï‚§ A higher value does not necessarily mean better performance.
ï‚§ The block size should be small enough to avoid IP fragmentation in
the client network (i.e., below MTU).
ï‚§ This feature is applicable only to TFTP servers that support this
option.
[ResetNow] Invokes an immediate device reset. This option can be used to activate
offline (i.e., not on-the-fly) parameters that are loaded using the
parameter IniFileUrl.
ï‚§ [0] = (Default) The immediate restart mechanism is disabled.
ï‚§ [1] = The device immediately resets after an ini file with the parameter
set to 1 is loaded.
Note: If you use the parameter in an ini file for periodic automatic
provisioning with non-HTTP (e.g., TFTP) and without CRC, the device
resets upon every file download.
Software/Configuration File URL Path for Automatic Update Parameters
[CmpFileURL]
Defines the name of the cmp
file and the path to the server (IP address or
FQDN) from where the device can load the cmp
file and update itself. The
cmp file can be loaded using HTTP/HTTPS, FTP, FTPS, or NFS. For
example, http://192.168.0.1/filename.
Notes:
ï‚§ For the parameter to take effect, a device reset is required.
ï‚§ When the parameter is configured, the device always loads the cmp
file after it is reset.
ï‚§ The cmp file is validated before it's burned to flash. The checksum of
the cmp file is also compared to the previously burnt checksum to
avoid unnecessary resets.
ï‚§ The maximum length of the URL address is 255 characters.

Table of Contents

Other manuals for AudioCodes Mediant 3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes Mediant 3000 and is the answer not in the manual?

AudioCodes Mediant 3000 Specifications

General IconGeneral
BrandAudioCodes
ModelMediant 3000
CategoryGateway
LanguageEnglish

Related product manuals