AudioCodes Mediant 3000 - Page 928

User's Manual 928 Document #: LTRT-89730
Mediant 3000
Parameter Description
[AMRCoderHeaderFormat] Determines the payload format of the AMR header.
 [0] = Non-standard multiple frames packing in a single RTP
frame. Each frame has a CMR and TOC header.
 [1] = AMR frame according to RFC 3267 bundling.
 [2] = AMR frame according to RFC 3267 interleaving.
 [3] = AMR is passed using the AMR IF2 format.
Note: Bandwidth Efficient mode is not supported; the mode is
always Octet-aligned.
Speex NB Bit Rate
[SpeexNBBitRate]
Defines the transmit (Tx) bit rate for the Speex narrowband codec
at clock rate of 8 kHz sampling rate.
 [1] 2.15 Kbps
 [2] 5.95 Kbps
 [3] 8.00 Kbps (default)
 [4] 11.0 Kbps
 [5] 15.0 Kbps
 [6] 18.2 Kbps
 [7] 24.6 Kbps
 [8] 3.95 Kbps
Speex WB Bit Rate
[SpeexWBBitRate]
Defines the transmit (Tx) bit rate for the Speex wideband codec at
clock rate of 16 kHz sampling rate.
 [0] 3.95 Kbps
 [1] 5.75 Kbps
 [2] 7.75 Kbps
 [3] 9.80 Kbps
 [4] 12.8 Kbps
 [5] 16.8 Kbps
 [6] 20.6 Kbps
 [7] 23.8 Kbps
 [8] 27.8 Kbps(default)
 [9] 34.2 Kbps
 [10] 42.2 Kbps
DSP Templates Table
DSP Template Mix Table
[DSPTemplates]
Allows the device to use a combination of two DSP templates and
determines the percentage of DSP resources allocated per DSP
template.
The format of the ini file table parameter is as follows:
[DspTemplates]
FORMAT DspTemplates_Index =
DspTemplates_DspTemplateNumber,
DspTemplates_DspResourcesPercentage;
[\DspTemplates]
For example, to load DSP Template 1 to 50% of the DSPs, and
DSP Template 2 to the remaining 50%, the table is configured as
follows:
DspTemplates 0 = 1, 50;
DspTemplates 1 = 2, 50;
Notes:
 The DSPVersionTemplateNumber parameter is ignored when