9500 Series Telephone User Guide Page 123
Issue 12b (Wednesday, March 28, 2018)IP Office™ Platform 11.0
Comments on this document? infodev@avaya.com
Phone Settings: Ringer Controls
17.6.3 Visual Alerting
The message waiting lamp at the top-right corner of the phone can also be used to indicate when you have a call alerting
your phone. The lamp is flashed to indicate a call waiting to be answered.
1. Press the button.
2. Use the up and down cursor keys to highlight Call Settings.
3. Press Select.
4. Use the up and down cursor keys to highlight Visual Alerting.
5. Press the Change soft key to change the setting.
6. When completed, press the Save soft key.
7. Press the Back / Exit soft keys to exit the menus.
17.6.4 Coverage Ring
If you have any bridged appearance and or call coverage buttons, you can set the type of ringing (coverage ring) that
should be used when a call alerts on any of those buttons. The options are to use normal ringing, a single non-repeated
ring (abbreviated ring) or no ring. The coverage ring setting is only used if you do not already have a connected call. If
you already have a connected call in progress, the shorter of the coverage ring and attention ring settings is used.
This is a user setting which will move with you if you hot desk another phone.
1. Press the Features soft key if shown. To do this during a call, press the PHONE key and then press the
Features soft key.
2. Use the up and down cursor keys to highlight Call Settings. Press Select.
3. Use the up and down cursor keys to highlight Coverage Ring.
4. Press the Change soft key to change the setting.
·
Ring - Use normal ringing.
·
Abbreviated - Use a single non-repeated ring (abbreviated ring).
·
Off - No ring.
123
To Next Page
Loading...
