User’s Manual—SNAP™ 500 Gen 1 and Gen 2 27
Classification: Avery Dennison - Public
If no IP address prints on the Network ID Test Label, the printer may not
have completed the DHCP process. Wait a few minutes and try again.
If there is still a problem, make sure the network cable is connected proper
and check the other network connections.
If you still cannot obtain a DHCP address, try resetting the printer to DHCP
mode as described in section 5.4.3.
Finaly, set the static IP address manually and test the network connect as
described above.
3.8 PCMate Platinum Software Installation
The software used to drive the AVERY DENNISON family of printers is covered
in a separate manual. The PCMate Platinum software is a Windows
®
application
used to create designs for the SNAP 500 printer as well as all other AVERY
DENNISON printers.
3.9 Printing a Test Label
3.9.1 Loading Supplies
Before you can print a test label, the printer must be loaded with tape and ink.
Refer to section 4.1 for instructions on loading the tape and ink.
3.9.2 Turning the Printer on
1. Turn the power switch on. The power switch is located on the back of the
printer, just above the power cord.
2. The four lights on the Printer Control Panel will come on for a few seconds,
and then all four lights will start to flash. This indicates that the printer is
performing its internal diagnostic tests. After several seconds, the lights will
stop flashing and the Ready light will come on. This indicates that the printer
is ready.
NOTE: During the power sequence the knife will cycle
backwards 1 time to find home and there will be an audible
bell as the printer powers up.
3. If any problems occur, Troubleshooting Sections.
To Next Page
Loading...
