Avery Dennison SNAP 500 - Table of Contents

User’s Manual—SNAP™ 500 Gen 1 and Gen 2
Classification: Avery Dennison - Public
Table of Contents
1.0 INTRODUCTION 9
2.0 SAFETY INSTRUCTIONS 10
3.0 INSTALLATION 12
3.1 Preparing for the installation 12
3.1.1 AC Power Line 12
3.1.2 Location Considerations 12
3.1.3 PC Requirements 13
3.1.4 User Safety 14
3.2 Receiving 14
3.3 Unpacking 14
3.3.1 Removing the printer from the carton 14
3.3.2 Inspection and Inventory Checklist 16
3.3.3 Downloading Support Documentation 16
3.3.4 Disassembly and Disposal 17
3.4 Printer Description 18
3.4.1 Component Descriptions 18
3.4.2 Printer Configurations 19
3.5 Printer Setup 21
3.5.1 Attaching the Stacker 21
3.5.2 Attaching the Unwind Assembly 22
3.5.3 Mains Disconnect 22
3.5.4 Installing the Power Cord 23
3.6 Communications Cable Installation 24
3.6.1 Serial Cable 24
3.6.2 USB Cable 24
3.7 Networking Setup 25
3.7.1 BIOS settings 25
3.7.2 Connecting the networking cable 25
3.7.3 Setting the Printer IP Address 26
3.8 PCMate Platinum Software Installation 27
3.9 Printing a Test Label 27
3.9.1 Loading Supplies 27
3.9.2 Turning the Printer on 27
3.9.3 Selecting the Test Format 28
3.9.4 Printing the Test Labels 28
4.0 OPERATION 29
4.1 Loading Supplies 29
4.1.1 Installing Ink to the Top Ink Supply Station(s) 29
4.1.2 Installing Ink to the Bottom Ink Supply Station 32
4.1.3 Loading the Stock 32
4.1.4 Butt Splice 34
4.1.5 Threading Diagrams – Gen 1 35
4.1.6 Threading Diagrams – Gen 2 35
4.2 Sending a Print Job to the Printer 37
4.3 Printing Labels 37