Avery Dennison SNAP 500 - Getting the UPG File; Getting UPG File Using D2 Comm; Getting UPG File Without Using D2 Comm

74 User’s Manual—SNAP™ 500 Gen 1 and Gen 2
Classification: Avery Dennison - Public
If you have one of these motherboards, you will need 3.30.16.15
MachSpeed P4MDPT
Red color
“P4KDPT” printed on board
Chaintech MP4M26A
Yellow/gold color
Chaintech” printed on heat sink next to processor
Fourth line of the BIOS reads “MP4M266A”
Epox EP-P4MKI-EP
Green color
“EP-P4MKI-EP” printed in white on the motherboard
near the memory slots.
Fourth line of BIOS reads “10/01/2004 for Apollo
P4M266A Chipset”
Biostar U8668-D
Red/purple color
“U8668-D printed on motherboard near memory slots.
Fourth line of BIOS reads “U8668-R35-D”
Biostar MCP6P M2+
Blue in color
“MCP6P M2+” printed next to heat sink. Connector
block on back of printing missing parallel port connector
(25 pin D-shall above serial and video connectors)
8.3 Getting the UPG file
8.3.1 Getting UPG file using D2Comm
The easiest way to get the UPG file is through D2Comm. If you have a D2Comm
account,
 Request your D2Comm Coordinator to schedule an upgrade for your
account.
 Log in to D2Comm, select “In Plant”, and then “Retrieve Updates”.
 The upgrade file will automatically download.
 Start PCMate to upgrade. There is no need to unzip this file as it will
already be a UPG file.
8.3.2 Getting UPG file without using D2Comm
You may download the upgrade file as follows:
1. Go to www.monarch.averydennison.com.
2. On the left, click “SUPPORT”, then “Printer Utilities, Firmware & Drivers”
3. Next in the Firmware second (2
nd
one down), click “Apparel Models – SNAP 500
& SNAP 700”