User’s Manual—SNAP™ 500 Gen 1 and Gen 2 41
Classification: Avery Dennison - Public
take up any slack and press the Start/Stop Button and close the appropriate
print-head rollers.
This alignment must be done only the first time you print
after power up, or after a “missed sense mark” error. Do
not align the tape after a normal stop or a stacker full.
To program the Contrast Sensor, see Appendix 10.5.
To use the Web Guide Hole Sensor, see Appendix 10.6
4.5 Option Menu System
The Option Menu System allows you to
Print test labels
Set the voice volume.
When the instructions say to press a button, press the
button for a short time and release it. When the
instructions say to press and hold a button, press the
button and hold it down until the printer responds.
When you are in the Option Menu System, you can get out
by pressing and holding the Voice button until the printer
says “Returning to print mode.”
Use the Start/Stop and Voice buttons to move through the Option Menu System.
Each time you press a key, a voice message will follow, or the machine will
initiate or stop an action. Regardless of which of the three functions you want to
select in the Option Menu System, you select it the same way:
1. Press and hold the Voice button for about two seconds: “Press Start for
Narrow Test Pattern.”
2. If you do not want to print a test pattern, press the Voice button: “Press Start
to Set Volume.”
3. If you do not want to change the speaker volume, press the Voice button:
“Returning to Print Mode.” At this time the Option Menu System is complete
and the printer is back to normal operation.
For more information on how to use each of the possibilities in the Option Menu
System, refer to sections for Running Test Labels; and Setting /Adjusting Voice
Button Volume.
To Next Page
Loading...
