Avery Dennison SNAP 500 - Page 97

User’s Manual—SNAP™ 500 Gen 1 and Gen 2 97
Classification: Avery Dennison - Public
Top of stack is blocking
incoming labels
1) Sensor not operational
1) Check sensor alignment
2) Stacker not connected
3) Loose connection
Stack of labels falling
over
1) Static brush position
1) Move static brush up or down
2) Platform angle
1) Move to other position
3) Tip stacker
1) Change angle
Label not entering
stacker
1) Label jam in knife
1) Clean out label and debris
2) Nip roller not pulling
1) Worn rubber roller - Replace
2) Loose set screw or drive gear - Tighten
3) Soft material / narrow web
hitting static brush
1) Adjust the height of the static brush