CHAPTER 4 – Installation
Chap. 4
- 9/20 -
4.2.3 Packaging and shipment precautions and tactics
Packaging is designed so that possible stresses or stains owing to transport do not exceed the
admissible values established by specific standards and do not cause permanent deformations or
damage that could negatively affect the performance of the machine or its components.
The machine can be transported using different types of packaging depending on destination and
transport modalities.
INFORMATION!
In the event of damage or lack of certain parts, contact Paolino Bacci Srl to agree upon the
procedures to adopt.
Depending on the characteristics of the machine or its parts, different devices and materials are used to
protect the machine or its parts during transport.
PACKAGING PRECAUTIONS 1 of 2
TYPE DESCRIPTION COMPONENTS
Nylon
protective film
• Nylon protective film is used as a dust-proof cover and
protection against light collisions and scratches of painted
parts.
• The film also partly protects the machine from gentle
atmospheric phenomena and prevents foreign material (dirt)
from depositing on the machine.
• Structure.
• Control
panels.
Grease
• The application of grease on surfaces or machine
components aims to protect the components from
atmospheric agents and prevent accumulation of foreign
material on the machine.
• Joints.
• Couplings.
• Guides.
• Bearings.
Protective
rustproof paint
• Application of protective rustproof paint on surfaces or
machine components aims to protect components from
atmospheric agents and corrosion phenomena.
• Machine parts subject to rust are covered with protective
paint:
o if the period between shipment and installation is
over 3 days.
o if the machine must be shipped by sea.
o in winter and in climatic zones where there is high
humidity.
INFORMATION!
Before the first start-up of the machine it is
necessary to clean the different components that
underwent protective treatment for shipment
purposes. Refer to the rustproof paint supplier’s
card for safety information on using masks/shields
and clothing to avoid contact with paint.
• Structure
• Screws
• Uncovered
parts
To Next Page
Loading...