TWIN – Use and maintenance instruction manual
Chap. 5
- 32/48 -
5.7 Equipping the machine
Only the operator in charge of running the machine may carry out the tasks described in this chapter.
This section contains all the information regarding machine equipping.
This chapter is divided into two parts. The first part deals with the tool, including safety
recommendations, tool choice, maintenance and presetting. The section part deals with how to block the
piece.
5.7.1 Tools
MAINTENANCE NOTE
Machine
maintenance
information
INFORMATION!
The tools to be installed on the machine must comply with the EN 847-1:1997
Directive.
STEP DESCRIPTION
1
Check the following parameters/data on the tool:
• Tool marking
• Manufacturer name
• Max number of revolutions
• Measurements: diameter, length...
• Tools must be marked.
• Work cycles
INFORMATION!
Tools must be marked and must comply with European Community directives. Check
the data on the information plate (1).
To Next Page
Loading...