CHAPTER 2 – Safety information
Chap. 2
- 27/52 -
2.9.1 Identification of work areas
The area around the main pushbutton panel and loading/unloading are the main operator
work areas from which the operator may enable commands, program work cycles and
check proper machine operation. For maintenance and to fit tools on the machine, the
operator must also access the safety enclosure.
2.9.2 Responsibilities of the operator in charge of running the machine
Before starting the work cycle, the operator in charge of running the machine must be
perfectly aware of the location and function of all the controls and of the machine
characteristics. The machine must be run only by operators who have been specifically
trained and have read the instructions contained in this manual thoroughly. Instructions,
warnings and general accident prevention regulations contained in this manual must be
followed scrupulously.
2.9.3 Responsibilities of the operator in charge of loading/unloading the machine
Before starting the work cycle, the operator in charge of loading/unloading the machine
must be perfectly aware of the location and function of all the controls and of the machine
characteristics. The machine must be run only by operators who have been specifically
trained. Loading and unloading operators must have read the instructions regarding piece
loading and unloading and the general safety instructions contained in this manual.
Instructions, warnings and general accident prevention regulations contained in this
manual must be followed scrupulously.
.
To Next Page
Loading...