CHAPTER 5 – Controls and use
Chap. 5
- 35/48 -
5.7.5 Balancing machine tools
Tools, tool holders and any spacers used must be dynamically balanced in G1.
MAINTENANCE NOTE
Machine
maintenance
information
INFORMATION!
Rebalance the tool and tool holder every time the tool is sharpened.
Improper tool balancing may lead to:
• The tool breaking,
• The tool coming off the spindle.
Balance the tools and tool holder in G1.
Rebalance the tools each time they are sharpened, in G1
.
NOTE
Safety warning
DANGER!
Danger of flying tool parts.
Use the following personal protective equipment (PPE): metal mesh gloves , when
replacing and handling tools.
Use the following personal protective equipment (PPE): safety glasses
when
sharpening tools.
To Next Page
Loading...