Bacci Twin - 4.3.2 Mechanical preparations for transport

TWIN – Use and maintenance instruction manual
Chap. 4
- 12/20 -
4.3.2 Mechanical preparations for transport
STEP ACTION DESCRIPTION
1
Safety checks
• Before working on any machine circuit or component, it is OBLIGATORY to
always verify that there is no residual voltage or pressure in the systems,
making sure that work is carried out safely and that all safety devices are in
place and working. Also make sure that all personnel in the vicinity have
been warned of the work being carried out.
Check that all operators are in a safe position and aware of the work being
carried out.
2
Warnings /
Precautions
•
Danger of bumping into the structure and machine parts. Move
cautiously during inspection work.
•
Danger of slipping, tripping and falling inside the machine. Move
cautiously during work.
3
Mechanical
block of axes
• To keep machine parts from moving during transportation, the linear axes
may be blocked into place mechanically.
• Wind a part of the ball screw (1) with a copper sheet (4) to protect it.
• Screw the block (2) on the part of the screw covered by the sheet (4).
Tighten the screws (5) against the surface of the structure (3).