Bacci Twin - Cleaning Tools and Tool Holders

TWIN Use and maintenance instruction manual
Chap. 6
- 24/32 -
6.5.3 Cleaning tools and tool holders
STEP ACTION DESCRIPTION
1
Clean
Dirt and/or excess oil on the contact surface reduces clamping strength.
• Clean the tool tang (2) and the tapered surface of the tool holder (1).
• Apply a thin layer of lubricant on the tapered seat of the spindle.
• Check the wear of the tool’s cutting edges. Replace the tool if the
cutting edge is damaged or dull.
• Use only tools/tool holders that have been balanced in G1. Rebalance
the tool every time it is sharpened.
NOTA
Safety
warning
DANGER!
Risk of flying tool parts.
Negligence during tool maintenance represents a major cause of accidents.
Clean and sharpen the tools.
Keep tools clean and sharp.
Balance tools in G1 every time they are sharpened.
MAINTENANCE NOTE
Machine
maintenance
information
Use only one of the greases specified above. Other products may be incompatible with
the product used by the manufacturer for initial greasing. Incompatible greases mixed
together or used one after they other may create substances that are damaging for
machine operation, thereby compromising machine safety.