TWIN – Use and maintenance instruction manual
Chap. 3
- 26/28 -
3.9 Machine identification
The machine and electrical board identification data are shown on the identification plates. The location of
the identification plates is shown in the figure below.
• The symbol
is present only on the machine identification plate and only for machines
marketed and sold within the European Community, accompanied by the relative EC declaration of
conformity, as per annex II A of the Machinery Directive 98/37/CE.
• The symbol
is not present on machines marketed and sold in countries that do not belong to
the European Community.
INFORMATION!
Do not remove the machine or electrical board identification plates. If the plates are damaged, always
contact the manufacturer.
The location of the plates is shown in the general layout (see ANNEX B TECHNICAL DIAGRAMS
AND GENERAL INFORMATION).
To Next Page
Loading...