CHAPTER 2 – Safety information
Chap. 2
- 29/52 -
Operation / Function Task N. Description Stage
Handling and transportation 07 Maintenance work carried out by
mechanical technicians and in part by
the machine operator (simple cleaning
and visual inspections).
Transport,
installation and
assembly
Various activities - inspection,
cleaning, etc.
08 Maintenance work carried out only by
electrical and electronic technicians.
Maintenance
Work on the electrical circuit 09 Maintenance work carried out only by
mechanical technicians.
Maintenance
Work on the pneumatic circuit 10 Maintenance work carried out only by
mechanical technicians.
Maintenance
Lubrication / greasing 11 Maintenance work carried out only by
mechanical technicians.
Use
SINGLE PIECE
loading/unloading (work
cycle)
12 Material loading/unloading with the
operator standing in front of the
machine, manually loading and
unloading the piece(s) on/from the
support devices located on the table.
Once the piece is placed, it is locked
by pressing the pedal button; then the
loading operation is confirmed, for the
machine to bring the piece in working
position (inside the machine, in the
machining heads area).
The closing of the clamps during the
stage when the operator interacts with
the support device, is performed at a
reduced pressure. The pressure is
then increased after confirmation of
loading end, by pressing the specific
button.
At the end of processing the piece is
automatically taken outside the
machine and the operator manually
removes it from the support devices;
then a new piece is loaded and
another processing cycle is started.
Use
To Next Page
Loading...