601–426 /17 F70 Series140
Image 8–64 Display setup Menu
2. Use the up / down arrow keys on the remote control to move the cursor to the “Display mode” position.
3. Use the left/right arrow key to scroll to IG pixelshift.
4. Select by pressing enter.
Status menu
When IG pixelshift is enabled, it will be visible in the Status Menu. (Scroll down a bit to see it), and also in the
LCD Information display.
Image 8–65 LCD Information Display.
8.9.2 IG Pixelshift Night Vision
General
In addition to IG pixelshift for daytime environment, the IG pixelshift Night Vision (NV) also includes the
functionality for running the pixel shift module when one of the input channels are used for IR content visible
through NV goggles.
This also includes a function of swapping visible light / IR light between the two inputs. This switch is default
set to IR channel being DVI1/DP1 and visible light being DVI2/DP2 as it is today This can be useful to swap
those two due to the fact that the input DVI1/DP1 has a lower latency than the DVI2/DP2.
Installation menu
To Next Page
Loading...
