157601–426 /17 F70 Series
How to set up DMX?
1. In the main menu, select Settings / Communications / DMX.
Image 10–11
The DMX menu is displayed.
Image 10–12
2. Choose the desired DMX mode.
3. Choose the desired starting channel.
4. Choose whether or not you want the Auto power-down feature to be enabled. If enabled, determine the
time-out.
5. If required, enable Art-Net. If enabled, determine the desired Art-Net Universe and Art-Net channel.
10.1.5 Trigger
About
There are 3 trigger outputs (2 on the F40 series) on the projector; one in the front and two on the back panel.
These outputs can be used for controlling external equipment.
The trigger outputs can be individually set to active low or active high by entering the menu Settings /
Communication / Triggers
System settings menu
To Next Page
Loading...
