145601–426 /17 F70 Series
Profile domain
name
Settings saved
Warp
• Warp status enabled / disabled
• Screen size
• Warp file selected (if available)
• Transport delay
Note: Bow and 4 corners warp cannot be saved.
Blend
• Blend mask enabled / disabled
• All Masks (top / bottom / left / right) and heights (top / bottom / left / right)
• Blend files enabled / disabled (if available)
• Blend file selected (if available)
Black level
• Black level file enabled / disabled
• Black Level file selected (if available)
• Basic black level enabled / disabled
• Black level settings (top / bottom / left / right)
• RGB gain values (Red, Green and Blue values)
HDR
• Screen luminance (unit and value)
• HDR Boost value
• DynaBlack mode
Installation
• Lens parameters (lens zoom, focus, shift and iris (if available))
2
• Orientation (mounting & projection)
• Scaling mode
• Position of motorized frame (if used).
• Shutter status (open or closed).
Cooling
3
Selected Cooling mode
Operational mode
4
Selected Operational mode
9.2 Saving the current projector settings in a
profile
Make sure the projector is fully configured as desired before saving the settings.
How to save the current projector settings?
1. In the main menu, select Profiles → Edit.
Image 9–2 Profiles menu, edit
The Profile edit menu is displayed.
GUI – Profiles
2. only valid if recalled with same lens
3. Only if external cooler is installed
4. Only for applicable models
To Next Page
Loading...
Need help?
General
