601–426 /17 F70 Series42
3.1 Approved Lenses
Approved Lenses
Partnumber
Description Compliance
R9801214 FLD 1.6 - 2.32 : 1 (EN11) approved
R9801218 FLD 0.74 : 1 (EN12) approved
R9801228 FLD 1.24 - 1.6 : 1 (EN13) approved
R9801209 FLD 2.37 - 3.79 : 1 (EN14) approved – professional use only
R9801225 FLD 1:16 : 1 (EN15) approved
R9801249 FLD 3.8 - 6.5 : 1 (EN16) approved – professional use only
R9801216 FLD+ 1.7 - 2.5 : 1 (EN41) approved
R9801226 FLD+ 0.8 : 1 (EN42) approved
R9801230 FLD+ 1.2 - 1.7 : 1 (EN43) approved
R9801211 FLD+ 2.5 - 4.6 : 1 (EN44) approved – professional use only
R9801220 FLD+ Long Focus 0.8 - 1.21 : 1
(EN45)
approved
R9801221 FLD+ Short Focus 0.8 - 1.21 : 1
(EN46)
approved
R9801295 FLD+ 0.65 : 1 (EN47) approved
PN_EN58 FLD+ 0.28 : 1 (EN58) approved
R9801832 0.38:1 (WUXGA) 0.57:1 (WQXGA)
This projector may become Risk Group 3 (RG3) when an interchangeable lens with throw ratio greater than
4.7 is installed.
Refer to the manual chapter 1.7 for the throw ratio versus hazard distance before operation.
3.2 Lens range
CAUTION: Always remove the lens from the lens holder before moving or transporting the projector.
Failure to do this may cause damage to the lens holder and prism.
Available lenses — WUXGA
The FLD lens range is custom-engineered for WUXGA and 1080 projectors.
The electrical connection to the lens motors is via a spring probe contact (pogo) pin array on the bayonet
mount.
The projector will automatically detect and identify the lens when it is installed. Automatic detection is not
available for 3rd party lenses.
EN11 EN12 EN13 EN14 EN15 EN16 EN33
Image 3–1
Lenses, Handling and features
To Next Page
Loading...
Need help?
General
