163601–426 /17 F70 Series
Image 10–23
The list of cities is updated according the selected region.
6. Select City and select the city corresponding with your time line.
7. Select Apply to activate.
10.4 Power saving settings
About the power saving features
In the aspect of continuous improvement, Barco has added several power saving features to the projector,
which will extend the lifetime of your projector and light source in particular.
From Pulse software 2.3.x onward, the following power saving features are available:
Feature
Description
Enabled /
disabled
Auto Dimming When no source with active signal is connected to the projector,
the OSD is not being projected, and no test pattern is active, the
light source will be dimmed to 50%.
Enabled by
default after the
first upgrade to
2.3.x or newer.
Auto light
source off
When no source with active signal is connected to the projector,
the OSD is not being projector and no test pattern is active, the
light source will be turned OFF after a configurable time-out
period. The projector will transition to Ready mode.
Most of the projector features will remain available while in Ready
mode.
Disabled by
default
Auto standby When the projector is in Ready mode and is not actively being
used (e.g. browsing through the projector GUI), the projector will
transition to either Standby or Standby ECO mode after a
configurable time-out period.
Disabled by
default
The difference between the Standby and Standby ECO mode is the following:
• Standby mode: After a set time-out, the projector disables most functionality to save power, safe the
communication options. This allows the projector to be awoken either using the local keypad, the RCU or
remotely using Projector Toolset or automation controllers (e.g. using DMX).
• Standby ECO mode: After a set time-out, the projector disables almost all functionality to save power,
safe a single small wake-up controller. This allows the projector to be awoken only using the local keypad
or the RCU. The projector can not be awoken remotely using this method.
How to change the power saving feature?
1. In the main menu, select Settings → Power.
System settings menu
To Next Page
Loading...
Need help?
General
