61601–426 /17 F70 Series
4.1 Installation process .......................................................................................................................62
4.2 Installation conditions....................................................................................................................62
4.3 Initial inspection............................................................................................................................63
4.4 Positioning the projector................................................................................................................64
4.5 Mounting the projector, general considerations ...............................................................................64
4.6 Projector safe attachment points....................................................................................................66
4.7 Throw distance.............................................................................................................................67
4.8 Scheimpflug (Boresight) introduction..............................................................................................69
4.9 Scheimpflug adjustment procedure ................................................................................................70
About
This chapter describes the physical conditions and procedures required when installing the F70 projector. It
also describes the outlines and some of the considerations that should be taken in to account when designing
and setting up the installation.
Each projector installation is unique, and as such the information in this chapter is only provided as a
guideline. Likewise, any images or graphical representations shown here are for illustrative purposes only.
If you require further information and assistance during the installation process, contact a qualified projection
technician or your local support office for advice.
Physical Installation 4
To Next Page
Loading...
Need help?
General
