601–426 /17 F70 Series152
10.1 Communication
10.1.1 Communication
About
Settings / Communication / LAN
Network connection is required to communicate with the projector via LAN or Internet.
Current Ethernet communication information is given, and can be edited in this menu.
Default mode for Ethernet communications are: Automatic ON / IP Version 4 DHCP mode.
Setting Description
Automatic
ON DHCP enabled
OFF Static
IP version 4
Static mode Set address, subnet mask and default gateway according to network
specification.
DHCP mode Assigned IP address, subnet mask and gateway.
Image 10–2
Manually set up the IP adress
Go to the menu Settings / Communication / LAN
Enable the Auto zone on the display and press enter. The Auto zone will change to “Manual”.
Scroll down, and modify the desired fields. When in the desired fields, press “Enter” to enable the virtual
keyboard, enter the desired values, and press “Enter” again to confirm the change.
10.1.2 Remote control
10.1.2.1 Broadcast address
About broadcast address
Broadcast address is a common address that can be set on the projector. That can be “0” or “1”. The default
broadcast address is '0'.
Any command coming from an RCU programmed with that common address will be executed.
How to the broadcast address
1. In the main menu, select Settings → Communication → Remote control.
System settings menu
To Next Page
Loading...
Need help?
General
