181601–426 /17 F70 Series
13.1 Setup 3D mode. ......................................................................................................................... 182
3D setup
The projector is capable of displaying 3D images and movies in both active and passive stereo 3D input mode.
Setup of a 3D installation requires an advanced understanding of the 3D systems, both for the projector, and
also for the signal source.
Regarding setup of the signal source, refer to the user manual for the specific unit.
In 3D setup, it is crucial that the projected images are perfectly synchronized through the whole signal path,
from the signal source to the picture viewed through the 3D goggles.
See instructions in this chapter to set up the projector for this feature.
Active stereo input.
One channel input. (One cable). Update frequency @ 120 Hz. Extra sync. signal must be used when DVI
source is used. For Displayport source, the sync signal is present in the signalcable, but external sync can
also be used when necessary.
Passive stereo input.
Use two channel input (two cables), one for each eye. Update frequency limited to 60 Hz for each channel.
Dual Sequential input source (DVI or Displayport) must be used. No external sync signal required.
3D 13
To Next Page
Loading...
Need help?
General
