723–0018 /02 F7090
Code E0000301: “Mainboard FPGA temperature exceeded” (Error)
For this error the same troubleshooting table can be applied to as for code E0000101: “Mainboard sensor
temperature exceeded”.
Code E0000401: “Mainboard Scaler FPGA temperature exceeded” (Error)
For this error the same troubleshooting table can be applied to as for code E0000101: “Mainboard sensor
temperature exceeded”.
Code E0000500: “Barometric pressure lower limit reached” (Error)
Situation Solution
Environmental pressure not
within range as normally
supported by the projector.
Ensure that environmental conditions comply with the operation
requirements of the projector. See installation manual of the projector for
detailed installation requirements.
Code E0000501: “Barometric pressure exceeded” (Error)
Situation Solution
Environmental pressure not
within range as normally
supported by the projector.
Ensure that environmental conditions comply with the operation
requirements of the projector. See installation manual of the projector for
detailed installation requirements.
Code E0000700: “Humidity too low” (Error)
Situation Solution
Wiring issue Verify the connection toward the humidity sensor.
Malfunction humidity sensor
(return value = 0)
Replace the sensor.
Code E0000701: “Humidity exceeded” (Error)
Situation Solution
Environmental humidity too
high.
Ensure that environmental conditions comply with the operation
requirements of the projector. See installation manual of the projector for
detailed installation requirements.
Code E1000101: “LaserDriver A bank 1 temperature exceeded” (Error)
Situation Solution
This error appears alone:
Lasersource bank 1 NTC
temperature exceeded due to
insufficient cooling of light
source.
Check the tube connections between both the cooler(s) and the light
source. Make sure the tubes are properly connected and check for liquid
spills or leakage.
Error appears alongside other
Cooler related errors.
Resolve cooler related errors first.
Troubleshooting
To Next Page
Loading...
