7. ICMP
7.8 Removing a HDD form the ICMP
In case the ICMP has to be returned to factory (e.g. for repair) the non defective HDD s should be remo ved and
kept.
How to remove a HDD ?
1. Switch off the projector.
Note: In case only one HDD fails it is allowed to h ot swap the HDD. To replace m ultiple failed HDDs the power m ust be switched
off.
2. Moving the latch towards the left.
Image 7-9
3. Push the unlock button to open the handle.
Image 7-10
4. Pull the HDD out of its slot.
Image 7-11
To install the HDD see p rocedure "Installing a HDD into the ICMP", pag e 118.
R5905963 PROMETHEUS SERIES 09/03/2015 117
To Next Page
Loading...
