4. Lamp & Lamp House
4. LAMP & LAMP HOUSE
About this chapter
This chapter describes how to insert a lamp house in the projector and h ow to replace a lamp inside the lamp house.
WARNING: DO NOT PER MIT UN AUTHORIZED PERSONNE L TO PERFORM OR ATTEMPT ANY PHASE OF
XENON LAM P HA NDLING OR SERVICE. ONLY TRAINED AN D QUALIFIED TECHNICAL SERVICE PERSONNEL
ARE ALLOWED TO HAN DLE THE XEN ON LAMP.
CAUTION: Xenon compact arc lamps are highly pressurized. When ignited, the normal operating temperature
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accordan ce
to the m anufacturer ’s instructions. The bulb is stable at room temperature, but ma y still explode if dropped or
otherwise mishandled. Whenever the lamp house, containing a xenon lamp, has to be dism antled or when ever
the protective container or clo th has to be removed from the xenon lamp, authorized protective clothing MUST
be wor n!
WARNING: Always wear face protection (full face shield) when handling xenon lamps.
WARNING: Always w ear pro tective clothing (welder’s jacket) when handling xenon lamps.
WARNING: Always w ear clean leather g loves with wrist p rotectors when handling xenon lamps.
Overview
• Introduction
• Supported xenon lamps for the S/M Lamp House
• Supported xenon lamps for the XL Lam p Hou se
• Removal of the Lamp Hou se
• Removal of the xen on lamp from manual S/M Lamp Hous e
• Removal of the xenon lamp from manual XL Lamp House
• Installatio n of the xenon lamp in manu al S/M Lam p House
• Installatio n of the xenon lamp in manual XL Lam p Hous e
• Check if anode su pport must be provided with a plain washer
• Installatio n of the Lamp House
• Resetting the lamp param eters
• Realignment of the lamp in its reflector (m anual Lamp H ouse)
R5905963 PROMETHEUS SERIES 09/03/2015
37
To Next Page
Loading...
Need help?
General
