102 BD FACSCanto II Instructions for Use
If the Lab Report countdown is set, recorded data displays in the Lab Report
view. A message shows the time remaining to view the report.
During the countdown, you can pause the run and do any of the following:
• Re-Gating a Plot Manually (below)
• Reapplying the Auto-Gate on page 104
• Re-Running a Tube on page 104
• Verifying Report Review on page 105
Re-Gating a Plot Manually
You can wait until the entire worklist has completed to review plots on the Lab
Report. However, if you prefer to re-gate plots during a worklist run, follow
these steps.
1 At the Lab Report Countdown dialog, click Pause.
To Next Page
Loading...
