15
Basic Mode
In Basic Mode you can measure and generate/simulate signals.
There are two separately configurable windows available. Basic
Mode is often used for testing connections before starting the ac-
tual calibration procedure of an instrument.
Stepping and Ramping tools enable generating/simulating signals
that vary with time.
All main functions of Basic Mode are described in part B of this
manual.
Part C concentrates on Basis Mode’s higher level functions and
additional information.
Maintenance
This main function handles calibrator configuration settings.
Additionally there is the possibility to recalibrate MC5-IS (requires a
password).
Maintenance level subjects are handled in Part C of this Manual.
Calibration Mode
MC5-IS’ main duty is calibrating instruments. Therefore very spe-
cial attention was directed on this matter when creating the calibra-
tor. MC5-IS may be used as a stand-alone calibrator i.e. all instru-
ment data and calibration history data is saved in MC5-IS’ own
memory. Optionally MC5-IS also communicates with calibration
software.
MC5-IS supports the use of instruction texts. They help the techni-
cian to perform the calibration as fluently as possible. You may en-
ter three kinds of instruction texts: Starting Guide, Adjusting Guide
and Finishing Guide. Additionally, calibration notes can be entered
after the calibration procedure.
More calibration related information is available in Part D of this
manual.
Calibration Results
The graphical representation as well as numeric data of the calibra-
tion results may be viewed in MC5-IS. Transferring the results to
QCAL
®
calibration software makes it possible to view the results in
PC environment.
More information concerning calibration results is presented in Part
D of this manual.
MC5-IS Firmware
To Next Page
Loading...
