WHEELS-BRAKES-
SUSPENSIONS
6
Loosen the screws (14) of the R.H. leg lower end .
Pull the front wheel axle (15).
Remove the wheel and recover the L.H. spacer (4).
IMPORTANT
To reassembly the front wheel perform the operations in reverse order taking care to properly
replace the L.H. spacer of the wheel axis.
If there isn’t enough clearance between brake disk and caliper body, the brake disks can be
damaged and the braking efficiency reduced.
If you have not used a torque wrench for the installation, make check as soon as possible from a
Bimota dealer that the installation is correctly performed.
Sub 6-4
To Next Page
Loading...
