USE
MAINTENANCE
3
3.2 – STARTING - ENGINE WARM UP
This vehicle is equipped with automatic choke (stepper motor).
These function allows you to automate the process of engine warm up.
Move the starting switch (1) to the ON position (2).
Verify that a green light N (gear in neutral) and red (oil pressure) on the dashboard are on.
Allow the engine to start spontaneously without operating the twist throttle.
IMPORTANT
Led that indicates the oil pressure has to go off a few seconds after starting the engine.
If the light is on, stop the engine and check the oil level. Do not start the engine if the oil pressure is
insufficient.
Press the starter button to start the engine
In case of the engine doesn’t start it’s necessary to wait at least 2 seconds before pressing the
button (3) again.
IMPORTANT
Do not operate the engine at high rpm.
When it is cold, wait for oil heating and for its movement at all points that need lubrication.
CAUTION
You can start the motorcycle with the side stand opened and the gearbox in neutral position, or
with the gear engaged, taking pulled the clutch lever (in this case the side stand must be closed).
Sub 3-5
To Next Page
Loading...
