USE
MAINTENANCE
3
3.8.1 - Calibration update program
NOTES
To carry out the control unit programming is necessary:
1. Make sure that ignition key is on OFF position.
2. Connect diagnosis cable cod. 506290140 to diagnosis connector
3. Insert the two-way “bridge connector” on the corresponding diagnosis cable
cod.506290140.
4. Place ignition key on the ON position.
5. Start the update calibration procedure described below.
Launch the updating calibration program of the control unit called “Windownloader-OEN 2000”.
It will appear the following screen:
Sub 3-59
To Next Page
Loading...
