bimota DB7 - Engine Torque Settings

TECHNICAL
SPECIFICATIONS
2
Engine torque settings
Description Size (mm) Torque (Nm) Notes
Idler and tensioner pulley mounting studs M20x1 50 LOCK 2 or TB1324
Camshaft pulley retaining nut M17x1 71 GREASE A
Rocker arm shaft covers M12x1,25 15 LOCK 2 or TB1324
Coolant temperature sensor on coolant outlet union M12x1,5 23
LOCK 4 – Restrain the insert
when tightening
Cylinder head nut:
Stage 1
Stage 2
Stage 3
M10x1,5
20
40
60
Apply GREASE C to the
underside of the nut and the
thread of the stud
Cam cap bolt:
Stage 1
Stage 2
M8x1,25
10
22,5
Engine oil
Coil retaining screw M6x1 10
Pulleys flange retaining bolts M6x1 10
Rocker cover bolt M6x1 10
Exhaust manifold stud M6x1 10 LOCK 2 or TB1324
Vacuum gauge connection screw on cylinder head M6x1 5 LOCK 2 or TB1324
Evaporative emissions canister fitting on cylinder head M6x1 5 LOCK 2 or TB1324
Air breather fitting on horizontal cylinder head M6x1 5 LOCK 2
Air breather blanking screw on vertical cylinder head M6x1 10 LOCK 6
Intake manifold bolt M6x1 10
Bolts securing coolant unions to cylinder head M5x1 8
Pre-applied Tecnologic 150
threadlocker
Oil cartridge M16x1,5 11 Engine oil on gasket
Oil cartridge nipple M16x1,5 42 LOCK 2 or TB1324
Oil pick-up pipe plug M14x1,5 24 LOCK 5 or TB1375B
Oil drain plug M12x1,5 20
Clutch cover oilway blanking plug M10x1,5 15 LOCK 5
Neutral sensor M10x1,25 10
Oil pump adapter bolt M10x1 LOCK 5 or TB1375B
Clutch cover inner oilway screw M10x1,5 15 LOCK 5
Cylinder head/barrel stud M10x1,5 25 LOCK 2 or TB1324
Hor. cylinder cover + swingarm attachment bolt:
Stage 1
Stage 2
M8x1,25
19
25
Vertical cylinder cover bolt:
Stage 1
Stage 2
M8x1,25
19
25
Sub 2-18