USE
MAINTENANCE
3
Liquid cooling level control
Check coolant level in the expansion reservoir on the right side of the vehicle, at the intervals
indicated in the "periodic service tab" .
The proper level should be between the MAX and MIN marks on the reservoir itself.
If the level is low it is necessary to provide for the topping;
Remove the right side fairing.
Unscrew the cap (1) and add a mixture of water and antifreeze liquid up to the mark
MAX.
Screw the cap (1) and reassembly the removed structures.
The liquid cooling prescribed must be mixed with water in the following percentages :
ANTIFREEZE: 35
÷ 40% of the volume
WATER: 65
÷ 60% of the volume
IMPORTANT
A particularly hard water with high percentage of mineral salts can damage the engine.
In the presence of particularly cold climates the percentage of antifreeze can be increased up to
55% of the volume.
IMPORTANT
A solution with a percentage of antifreeze less than 30% does not provide adequate protection
against corrosion.
Sub 3-14
To Next Page
Loading...
