bimota DB7 - Calibration Update Program; Installation of Ecugloader-1000 Program (Use for ECUG)

USE
MAINTENANCE
3
3.9. - Installation of EcugLoader-1000 program (use for ECUG)
For the installation from CD:
1. Insert the CD in the player
2. Copy the content of file ECUGLOADER-1000 on your PC where is more suitable for you.
3.9.1 - Calibration update program
NOTES
To carry out the control unit programming is necessary:
− Make sure that ignition key on OFF position
− Connect diagnosis cable cod. 506290140 to diagnosis connector
− Insert the two-way “bridge connector” on corresponding diagnosis cable cod.506290140.
− Place ignition key on the ON position.
− Start the update calibration procedure described below
Launch the updating calibration program (ECUGLOADER-1000) of the control unit
Sub 3-61