USE
MAINTENANCE
3
Repeat this last action until fluid free of air bubbles will come out from the transparent hose.
Tight the bleeding valve (2) to the prescribed torque and install the protection cap.
Bring the fluid at about 3 mm above the MIN reference level of the reservoir.
Re-screw the cap (1) with the membrane.
Steering bearings clearance adjustment
If there is an excessive handlebar movement or shaking of fork respect to axis
it is necessary to proceed to adjust the steering bearings clearance in the following way:
Loosen the screws (1) and (2) on the steering head triple clamps.
Sub 3-32
To Next Page
Loading...
