USE
MAINTENANCE
3
Check-up before run
Failure of the inspections before leaving can cause damage to the vehicle and result in serious
injury to the rider.
Before traveling check the following points:
- control the level of fuel in the tank.
- control the tension and lubrication of the drive chain.
- check the right functioning of all the service lights.
Engine oil level
Control the level in the sump through inspection window. Fill up with recommended oil.
Brake and clutch fluid
Check on their reservoirs the liquid level.
Coolant
Control the level of liquid in the expansion reservoir; fill up if needed.
Tire condition
Control the pressure and the wear of the tires
Command functionality
Move the brake lever and brake pedal, clutch lever, twist throttle, shift lever and check the
functionality.
Lights and signals
Verify the integrity of the bulbs for lighting, for turn signal and the horn functionality. In the case of
burned bulbs replace them with other similar as shown.
Locking
Check the locking of the fuel tank cap and of the saddle.
Side stand
Check the functionality and the right positioning of the side stand.
Sub 3-4
To Next Page
Loading...
