WHEELS-BRAKES-
SUSPENSIONS
6
Rear shock
The rear suspension uses a fully adjustable progressive hydraulic monoshock with an interposed
rocker arm between the frame and the shock bottom fulcrum. The shock is adjustable in rebound
and compression (both at high and low speeds) and preload spring. The swing arm pivots on the
engine and the engine plates.
Rear shock removal
Remove the rear wheel.
To remove the rear shock (12) from the swing arm and rocker arm (10) it is necessary to unscrew
and slip the upper screw (25) off then slip the lower screw (18) off and the respective lock-nuts.
Check visually the shock and identify any oil leak or other problems. Replace the shock, if
necessary.
IMPORTANT
For any problem related to shock functioning, contact Bimota authorized dealer.
Sub 6-26
To Next Page
Loading...
